1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 191Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 191

I1ID 20Wrap the housing with shop clothRotate the detent lever 90 in either direction, then pull the detent lever out of
use OMC Bearing Remover and Installer, PIN 391257, and assemble it as follows: 221 V4 -20 12 inHex Head Screw in0.0Flat Washer
PIN 326582 Rod PIN 391260 Plate PIN 326574 Remover -20 inHex Head Screw Position the tool in the gearcaseUsing mallet, drive
the bearing from the gearcase231 V6 (f) Flange Nut, PIN 326586 Plate, PIN 391260 Rod, PIN 326582 Remover, PIN 326579 Make
sure all 18 needle bearings are inside the bearing case before pulling the bearingThe needle bearings provide surface for
the remover to pull againstUse ps inwrench to hold the remover in placeUse 3f4 inwrench to turn the flange nut clockwiseDraw