1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 192Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 192

12411251 24Inspect the water intake screen for blockageRemove the screen by using one of the following methods: Depress tabs
the bearing3Discard the bearing housing O-ringClean the housing and bearings in solvent, and dry thoroughlyIf bearings were
not replaced, rotate the needles with your fingers to check for freedom of movementInspect O-ring groove, and sand off any
sharp edges that would cut O-ring and prevent its sealing 4Inspect the bearing housing anodeReplace anode if it has reduced
to two-thirds of its original size (one-third eroded) rn 5Oil, then install new bearings in the bearing housing V4use OMC
Bearing Installer, PIN 326562, to install the forward bearing and rear bearing V6use OMC Bearing Installer, PIN 339750, to
install the forward bearing and rear bearing Place the lettered end of the bearing case on the bearing installer, then press