1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 193Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 193

6 DR2061-DR2062 [] 6V4Use OMC Seal Installer, PIN 336311, to install two new seals back to back in the rear of the bearing
OMC Triple-Guard grease to the seal lips after installing[] 8Lightly apply OMC Triple-Guard grease to new bearing housing
O-ringInstall the O-ring in its groove in the housingDriveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace
the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged[[]
1Remove the two driveshaft bearing housing seals using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Discard
the seals2Remove the O-ring from the bearing housing and discard3Clean the bearing housing in solvent to remove sealer from
the seal bore and the O-ring groove14155 DRC5721 4Install new seal in the bearing housing using OMC Seal Installer, PIN 341439Apply