1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 195Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 195

1Assemble the driveshaft bearing housingthrust washerthrust bearingand pinion onto the driveshaftUse OMC Driveshaft Seal
and measuring the clearance between the gauge bar and the bearing housing with feeler gaugesMeasure between each pair of
screw holesReplace the bearing housing and repeat check if variance exceeds 0.004 in(0,010 mm) 5Rotate the driveshaft several
revolutions to seat bearings 8Check the squareness of the pinion to the driveshaft by holding the gauge bar against the bearing
housing (between the screw holes) while rotating just the driveshaft and pinion assembly and measuring the clearance between
the gauge bar and the pinionReplace the pinion or the driveshaft, as necessary, and repeat the check if variance exceeds
0.002 in(0,050 mm) 9Subtract the average clearance measurement you obtained in Step from 0.020 in(0,508 mm) to determine
the correct shim thickness requiredSelect the fewest number of shims to achieve the correct thickness10Remove the driveshaft
from the tool baseRemove the collar and bearing housing from the driveshaft, and add the required amount of shims INote Use