1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 196Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 196

11Check shimming by reassembling the driveshaft with shims and placing it back into the tool baseThe measurement between
Assembly Grease to the 18 needle bearings and insert them into the bearing case3V4, V6Place the bearing on the installer
tool with the lettered side of the bearing facing the top of the gearcaseUse OMC Needle Bearing Assembly Grease to hold the
bearing on the tool V6Incorrect installation of the pinion bearing in the gearcase drastically reduces the life of the bearingThe
bearing is tapered so that when installed correctly, its shape compensates for stresses in the gearcase and allows full bearing
contactWhenever gearcase is disassembled, the pinion bearing should be checked to ensure that it has been installed with
the lettering facing up4V4, V6 -Insert the tool with the bearing into the gearcaseDrive the bearing into the gearcase until
the washer on the tool contacts the spacerRemove the toolUsing rag, remove any excess grease from surface of the needle bearings