1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 199Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 199

COA3168 20Move shift rod from side to side while pushing on the propeller shaft to ensure proper alignment of the bearing
bearing housingDo not coat inside bearing housing bore surface of the gearcase24Using OMCDriveshaft Seal Protector, PI 318674,
slide the driveshaft bearing housing onto the driveshaft25Pull up on the shift rod to engage FORWARD gearTurn the gearcase
upside down by rotating the holding fixtureBe sure any excess grease is removed from the pinion needle bearingsDegrease inside
taper of the pinionPosition the pinion in the gearcase26Degrease the driveshaft taper and install the driveshaft27Lightly
coat the threads of the pinion nut with outboard lubricant and install on the driveshaftTurn the driveshaft by hand to engage
the nut 1221 28Turn the gearcase right side upUsing OMC Driveshaft Socket, PIN 311875, and OMC Pinion Nut Holder, PIN 334455,