1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 200Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 200

29Position the washers on the driveshaft bearing housing screwsApply OMC Gasket Sealing Compound to the threads of the screwsInstall
position and anode facing downPress the bearing housing into the gearcase and tap the housing with soft face mallet to seat
the O-ring 127 12s1 33Install the two retainers, washers, and screwsApply OMC Ultra Lock-271 to threads of the two retainer
screwsInstall the screws and torque them to 24-26 ftIbs(33-35 Nm)34Before installing lubricant, pressure test and vacuum
test the gearcase as follows: Remove the oil level plug, and screw in pressure test gauge Pump up pressure to 3-6 PSI (21-42
kPa)If pressure gauge indicates leakage, submerge the gearcase in water to determine source of leakage as evidenced by bubblesIf