1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 210Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 210

1351 21 Push the propeller shaft out of the bearing housing1361 22Remove the thrust bearing and thrust washer 1371 23Remove
thoroughlyIf bearings were not replaced, rotate needles with your fingers to check for freedom of movementInspect O-ring
groove and sand off any sharp edges that would cut O-ring and prevent its sealing 391 26To replace the large bearing, lightly
coat the outside case with gearcase oilFace the lettered end of the bearing case toward the large diameter end of OMC Bearing
Installer, PIN 432401, and slide it onto toolPress bearing into housing until the tool seats1401 27To replace the small bearing,
lightly coat the outside case with gearcase oilPlace lettered end of bearing case on small diameter end of OMC Bearing Installer,