1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 220Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 220

2533Lightly apply OMC Triple-Guard grease to new O-ringand install it on the bearing housingCarefully apply OMC Gasket Sealing
gauge indicates leakage, submerge the gearcase in water to determine source of leakage as evidenced by bubblesIf the gearcase
pressure gauge does not indicate leakage, increase pressure to 16-18 PSI (110-124 kPa)If pressure does not hold, submerge
the gearcase in water and check for source of leakageMake necessary repairs and repeat test Screw in vacuum testerPump outto
3-5 in(76-127 mm) of mercury and see if vacuum holdsThen, pump out to 15 in(381 mm) of mercury and checkIf the gearcase fails
to hold on either test, put oil around suspected sealIf leak then stops or oil is drawn in, that seal is defectiveWhen the
gearcase checks OK, refill with the proper lubricant 29Fill the gearcase with lubricant as follows: Secure the gearcase in
an upright position Remove the oil level plug and the drainfill plug Replace their seals, if damaged Fill the gearcase with