1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 227Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 227

19Remove retaining ring if requiredDiscard retaining 20To assemble bearings to driveshaft, install new retaining ring (if
lower bearing 22Using retaining ring pliers, install retaining ring with sharp edge facing outMake sure the retaining ring
is seated in its groove in the driveshaftWear safety glasses and proceed with care to avoid unsnapping the ring from the
pliers 23Install thrust washer against upper bearing with dished center section facing upwardPlace upper seal carrier assembly
onto the driveshaftApply OMC Triple-Guard grease to two new O-rings and install on upper seal carrier24Fill bearing housing
cavity with OMC Marine Wheel Bearing Grease25Heat the bearing housing slightly with propane torchPress the driveshaft and