1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 263Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 263

5With the engine running at 1000 RPM, the voltmeter should indicate volt If the voltmeter shows specified voltage, go to
horn circuitRefer to Warning Horn, Section If the voltmeter shows voltage, go to Step 9 rn 9Separate the rectifierregulator
gray lead bullet connectorRemove the voltmeter red lead from jack "c" and connect it to the rectifierregulator gray leadWith
the engine not running and the key switch in the "ON" position note the voltmeter reading If voltmeter does not show voltage,
go to Step 1O If voltmeter shows voltage, replace the rectifier regulator 10With the engine not running and the key switch
in the "ON" position, connect voltmeter to engine wiring harness gray leadDisconnect the tachometer from the circuitCheck
to see if voltage disappears, then disconnect the pump's 4-pin Amphenol connector and check voltage If voltage disappears
after disconnecting component, replace that component If voltmeter shows voltage after disconnecting both components, substitute
the remote control wiring harness with known good harnessIf voltmeter still shows voltage, replace the engine wiring harness