1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 285Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 285

7(continued) If no voltage atV3disconnect bluewhite tilt limit switch bullet connectors and re-connect to by-pass tilt limit
black wire between relay bracket and engine ground If voltage at V5go to Step 1414Connect voltmeter black lead to clean engine
ground, and voltmeter red lead to V7 (greenwhite)15Push control box DOWN trim button If no voltage at V7check control box
trim switch and wiring, and go to Step 16 If voltage at V7go to Step 16 OJ 16Push lower motor cover DOWN trim button If no
voltage atV7check for voltage at greenwhite bullet connector out of lower motor cover trim switchCheck for voltage at redwhite
connector that supplies lower motor cover switch If voltage at V7go to Step 1717Reinstall DOWN relayPush blades only halfway
into bracket in DOWN (green) end of bracket 18Push DOWN trim button and check for voltage at V8 on relay blade (M terminal
of relay) If no voltage at V8go to Relay Ohmmeter Test If voltage at V8go to Step 19 19Disconnect trim motor's blue and green