1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 291Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 291

1sl 7Install pressure gauge and adapter "A" to check problems in the UP circuitTighten gauge and adapter lightly to 5-10
and 8, install pressure gauge and adapter "B" to check problems in the DOWN circuit12Starting with the tilt cylinder fully
extended, run the unit DOWN The gauge should show 0-200 PSI (0-1379 kPa) as the tilt cylinder is retracting The gauge should
show (5516 kPa) as the unit stallsapproximately 800 PSI 27343 Release the switch and watch for pressure dropThe stall pressure
reading must not drop by more than 200 PSI (1379 kPa) after the motor stops13If you test resu Its vary from those inStep
12, problem in the DOWN circuit is indicatedRefer to Hydraulics Troubleshooting, this section i then UP again to vent any
high pressure before removing the gauge '" 14After tests are complete, jog the unit UP, then DOWN, 15Install the manual release