1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 295Get this manual

1995 Johnson Evinrude "EO" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 503151, Page 295

Disassembly & Jog the trim motor UP, then DOWN, then UP again to vent any pressure at the manual release valve before removing
it after it is completely assembledPainting of individual components may cause flakes of paint to enter the hydraulic passages
during assemblyTape the trim and tilt piston rods before painting 1Screw the manual release valve inRemove the retaining
ring using retaining ring pliersRemove the manual release valve 2Inspect O-ring and two plastic split rings on the manual
release valve for nicks and cutsInspect tip of valve for damageThe two plastic split rings are not available separatelyIf
rings are damaged, replace the manual release valve rn rn 3.Inspect the reservoir the capdrain the fluid into Remove cap
and O-ring in container[]] 4Remove the three Pozidriv screws securing the reservoir to the cylinder bodyRemove the reservoir23370