1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 48Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 48

Synchronization and Linkage Adjustments 25,28,30 I Note It is important that this step-by-step procedure be followed in sequence
Control Rod 1Tiller modelsturn the idle adjusting knob counterclockwise to full SLOW position I Note Offset on pivot block
rod collar must face toward the control 1While rotating the propeller shaft, move the shift lever to FORWARDLoosen the control
rod collar screw []] 2Advance the throttle lever until it contacts the stop on the cylinder block3Move the throttle control
rod forward until the carburetor throttle plate is horizontal[]] 4Move the control rod collar backward until it touches the
pivot blockTighten the collar screw securely[]] 5Check your adjustmentThe carburetor throttle plate must be exactly horizontal
when the throttle lever is fully advancedIf necessary, repeat Steps thru 4Maximum Spark Advance INotel Run the engine with
the proper test wheelDo not run the engine with propeller or flushing adapter for the adjustment1Connect timing light to