1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 51Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 51

Remote Control Cable Installation Engine, 9.9 thru 30 & To prevent accidental starting of engine, verify that battery cables
with installationThrottle Cable9.915 1Remove the rubber grommet from front of lower engine coverRemove cable retainerApply
liberal amount of OMC TripleGuard grease to both anchor block pockets rn 2Extend throttle cable and lubricate with OMC Triple-Guard
grease3Move the remote control handle to NEUTRALVerify that the fast idle lever is down in the RUN position4Attach cable
casing guide to throttle lever using clevis pin and cotter pin supplied with engineSecure cable by spreading cotter pin ends5Hold
throttle lever tight against idle stop screw6Pull firmly on throttle cable to remove backlash and install trunnion nut in
anchor pocket7Install cable retainer and torque screw to 60-84 inIbs(7-9 Nm) 8Check cable adjustment: If throttle cable adjustment