1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 80Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 80

[[] Assembly INotel Before proceeding, be sure that all parts are perfectly cleanBe sure that all replacement parts match
Use notch that is indicated "9.915 HP Be certain gauge is not holding down the float If float level is not between the notches
of gauge, lightly bend metal float arm to adjust levelBe careful not to force float needle valve into seat 6Check for correct
float drop dimensionThis dimension affects the full opening of the inlet needle and is critical to correct operation of the
carburetorWith carburetor body in normal running position, the float must drop open to dimension shownTo adjust, bend tab
on float arm where tab contacts float seat []] Q) Base of carburetor body Bend float lever tab to achieve proper dimension
CD into 13a in(25-35 mm)7Place the lower gasket into the float chamberInstall the float chamber and bowl gasketTighten the
screws to torque of 8-10 inIbs(0,8-1,2 Nm), following sequence embossed on float chamber8Install the carburetor body cover