1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 88Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 88

[[] Assembly INote Before proceeding, be sure that all parts are perfectly cleanBe sure that all replacement parts match
down the indicated "9.915 HP Be certain gauge is Use notch that is not float If float level is not between the notches of
gauge, lightly bend metal float arm to adjust levelBe careful not to force float needle valve into seat6Check for correct
float drop dimensionThis dimension affects the full opening of the inlet needle and is critical to correct operation of the
carburetorWith carburetor body in normal running position, the float must drop open to dimension shownTo adjust, bend tab
on float arm where tab contacts float seat Q) Base of carburetor body Bend float lever tab to achieve proper dimension in
to Pis in(25-35 mm) 7Place the lower gasket into the float chamberInstall the float chamber and bowl gasketTighten the screws
to torque of 8-10 inIbs(0,8-1,2 Nm), following sequence embossed on float chamber8Install the carburetor body cover and gasketTighten