1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 118Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 118

Ignition Plate Servicing20 thru 30 Removal 1To avoid accidental starting of engine while servicing, twist and remove all
the washers on the crankcase bosses using OMC Needle Bearing Assembly Grease to stay in position[]] 2Lubricate the top side
and underside of stepped washer, with OMC Moly Lube, where it contacts the retainer and pilot ringPosition the stepped washer
and pilot ring on the retainer48-60 inIbs(5-7 Nm) 3Install the four screws to retain the pilot ringTorque to 4Lubricate the
thrust washer with OMC Moly Lube and place in ignition plate5Apply OMC Nut Lock to ignition plate screwsLower ignition plate
onto retainer and torque screws to 25-40 inIbs(2,8-4,0 Nm) 6Check for sufficient slack on ignition component leads during