1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 119Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 119

Ignition Component Replacement 1To avoid accidental starting of engine while servicing, twist and remove all spark plug leads[]]
spiral wrapINote All component leads must be routed through clamp and plate in single layer, not twisted or crossed over
another lead 9Apply OMC Nut Lock to the threads of the ignition plate screwsInstall the ignition plate on the retainer plateTorque
retaining screws to 25-35 inIbs(2,8-4,0 Nm)10Check for sufficient slack on ignition component leadsRoute component leads
through wire clamps[[] 11Position OMCLocating Ring, PIN 334994, over machined bosses on the ignition platePush the locating
ring in toward the component to be installedHold the ring in place and pull the component out toward the ringTighten screws