1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 138Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 138

Thermomelt Stik Procedure 1Install correct test propeller and place engine in test tank i pellers, twist and remove all spark
to 5000 RPM, the 1630 (730 C) mark should remain dull and chalky If the mark becomes liquid and glossy, troubleshoot the
cooling system for causes of overheating Removal of Upper Crankcase Seal9.915 The presence of oil under the flywheel could
indicate leaking upper crankcase sealThe upper crankcase seal can be replaced without disassembly of crankcaseRemove the
flywheel as described in Section 3Use OMC Seal Remover, PIN 391060, to remove and install the seal To remove seal, install
tip "C" into removerinstaller bodyThread removerinstaller body with tip into seal to engage metal caseWhile holding removerinstaller
body, turn pressing screw and remove seal To install new seal, apply OMC Gasket Sealing Compound to the outside diameter