1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 148Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 148

Cleaning Before inspecting or assembling powerhead, all internal components must be perfectly clean and free of contaminants1Remove
wear eye protection and rubber L!!J traces of gaskets, adhesives, and 4Use OMC Gel Seal and Gasket Remover to remove all
OMC Gel-Seal I from the cylinder block and crankcase5Carefully remove any carbon accumulation from the tops and ring grooves
of the pistonA ring groove cleaning tool can be made by breaking an old ring and grinding an angle on its endDo not damage
ring grooves while cleaning 6Thoroughly wash entire cylinder block and crankcase with warm, soapy water to remove all traces
of contaminants i compressed air pressure at less than 25 PSI (172 kPa) To avoid personal injury, wear eye protection and