1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 151Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 151

Assembly Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly
the 22 needle bearings and install the bearings into the connecting rod f513Slide one of the wrist pin washers down the wrist
pin rJ 4Slide the connecting rod with the needle bearings and washer up and off the wrist pin, being careful not to disturb
the bearingsPlace the connecting rod and the two wrist pin washers in position in the piston cavity, aligned with the wrist
pin boss,15Finish installing the wrist pin through the connecting rod and the piston until the wrist pin contacts the installed
retaining ringCheck to be sure none of the needle bearings have been disturbed and pushed out of the connecting rodInstall