1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 156Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 156

Installation INote Remove the gearcase as described in Section 6This will aid in guiding the water tube into the water pump
rn Guide the small water tube into the opening in the rn rear of the exhaust housingW Apply OMC Gasket Sealing Compound to
the six powerhead retaining screws and install the screwsTighten the six powerhead retaining screws to torque of 60-84 inIbs(7-9
Nm) & 5Adjust the neutral start switchINote To avoid permanent powerhead damage, instruct operator to repeat the original
engine break-in procedure as described in Section before putting engine back into normal service Neutral Start Switch Adjustment9.915
TE INote Disconnect the battery cables at the battery OJ 1To test, shift motor into NEUTRAlDisconnect the starter motor red
wire at the motor2Attach continuity light or ohmmeter between the starter wire and the neutral start switch wire at the electrical