1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 175Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 175

4612Use feeler gauge to check groove side clearance on the lower square ringsInstall each square ring on its pistonWith the
components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant 3521 Lightly lubricate
the three water deflectors with STP Oil TreatmentInstall the two long and one short water deflectors until they are flush,
or nearly flush, with the gasket surfaceDO NOT shorten the water deflectorsThe water deflectors might be slightly above the
gasket surface in normal installation2Determine which part of the piston faces up by holding the piston next to the cylinder
blockWhen installed, the sharp edge of the piston deflector will face the intake ports f31 3Apply OMC Needle Bearing Assembly
Grease to the 28 wrist pin bearingsInstall the bearings in the wrist pin boreAlign the bearings in the bore using OMC Wrist