1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 176Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 176

5The connecting rod has no specific orientationSupport the piston in OMC Piston Cradle, PIN 326573Oil the wrist pin bore
with OMC Triple-Guard grease r,()l 11To install new lower main bearing: Oil the end of the crankshaftUse OMC Crankshaft BearinglSleeve
Installer, PIN 339749, and place bearing onto crankshaft with lettered side facing the toolInstall bearing until it seats
in the crankshaft G1l 12To install new crankshaft sleeve: Oil the end of the crankshaftPlace the sleeve in OMC Crankshaft
Bearingl Sleeve, PIN 339749, and drive the sleeve onto the crankshaft until the installer contacts the lower main bearing
If the installer sticks on the sleeve after installation, thread OMC Slide Hammer, PIN 391008, onto installer and pull offInspect
sleeve surface after installingSleeve must not be used if surface is damaged f.i21 13Lubricate new driveshaft -ring and lightly
lubricate crankshaft splines with OMC Moly LubeInstall -ring in sleeve -r;3l 14Using retaining ring pliers, install lower