1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 211Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 211

Isl 8Remove the three screws retaining the idle relief mufflerRemove the mufflerDiscard the muffler gasket and seals from
of the exhaust housing that retain both lower side mounts to the exhaust housing15Refer to Cleaning and Inspection at the
beginning of this sectionAssembly and Installation If not otherwise specified, apply OMC Gasket Sealing Compound to threads
of all screws f101 1Apply OMC Gasket Sealing Compound to the threads of lower side mountsInstall the two lower side mounts
Tighten the nuts to torque of 144-168 inIbs(16-19 Nm)f101 f111 2Install the lower front and the upper side mounts to the
exhaust housingf131 3Install the lower motor cover bracket to the exhaust housingApply OMC Adhesive to the seal surface of
the exhaust housingPosition new exhaust housing to lower engine cover seal f11l f12l 4Apply OMC Gasket Sealing Compound to
threads of the upper side mountsPlace front of the exhaust housing over the upper front mountPush lower part of the exhaust