1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 235Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 235

Assembly Make no dry assembliesLubricate bearings, shafts, and gear with OMC Ultra-HPF gearcase lube rv bearingthe small
into the housing until the tool is seatedApply OMC Triple-Guard grease to the seal lips after installing4Apply OMC Triple-Guard
grease to new bearing housing O-ringPlace the a-ring in the bearing housing groove5To install the forward bearing cup into
the gearcase, remove the gearcase from the holding fixture, and place the nose of it on wooden blockDrive in the bearing
cup with mallet and OMC Bearing Cup Installer, PIN 319929, attached to OMC Drive Handle, PIN 3118801s16Install the pinion
bearings using the following components of OMC Universal Pinion Bearing Remover and Installer, PIN 391257, and one additional
tool spacer: 326578 Removerllnstaller -20 12 inScrew -20 inScrew inFlat Washer PIN 326585 Spacer, Short PIN 339753 Spacer,