1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 237Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 237

1121 14Position the thrust bearingwasher on theother thrust one pinion thrust pinionOil and install Install the on the pinion15Install
it into the yoke until seatedThen back out shift rod until slotted face of connector faces the driveshaftf171 19Using long-nose
pliers, place the clutch dog in the cradle with grooved side facing the forward gear [!!] INotel Groove on the clutch dog
must face the forward gear20Apply OMC Needle Bearing Assembly Grease to the propeller shaft spring and two detent ballsInstall
the spring and balls in the propeller shaftAlign the two detent balls with the two grooves in internal splines of the clutch
dog21Aid installation of loose detent ball with flat blade screwdriverPush the propeller shaft into the clutch dog, forward
gear and the forward bearing22Hold propeller shaft in place and move shift rod up to NEUTRAL position23Slide the reverse