1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 288Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 288

Assembly & Wear safety glasses while disassembling and assembling manual starters because of rewind spring tension 1Using
direction shown on the toolWind the spring into the starter winder base until end of rewind spring contacts the starter winder
base 4Remove the crank retainer screw and the crank and pin assembly from the starter winder base 5Remove the adapter release
plate with the rewind spring from the starter winder base ITTI 6Install the rewind spring into the starter housingLocate
7Place the starter spring shield with holes onto the pulley the outer loop of the rewind spring on the pin in the starter
housingPress down through the holes of the adapter release plate to transfer the rewind spring into the starter housing Safety