1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 289Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 289

8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the pin of the pulley with the
that protrude through the starter housing with OMC Locquic PrimerApply OMC Nut Lock to the threads of the nutHold the spindle
screw and torque the nut to 120-145 inIbs(14-16 Nm) 12Tie knot in one end of the starter ropeWith the starter housing upside
down on bench, wind the pulley counterclockwise until the rewind spring is tightBack off the spring about 112 to turnThread
the starter rope through the hole in the pulley, behind roll pin in pulley, and out through the starter housing13Apply OMC
Triple-Guard grease or Lubriplate 777 to the handle end of the starter ropeUsing OMC Starter Rope Threading Tool PIN 378774,
thread the starter rope through the handlePress the starter rope into the channel of the rope anchor, with end of starter
rope butting firmly against end of channelPress the anchor into the handleTug on end of starter rope to seat the knot against