1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 312Get this manual

1995 Johnson Evinrude "EO" 9.9 thru 30, 2-Cylinder Service Manual, P/N 503146, Page 312

4Remove pinion and base []] INote Before disassembly, scribe marks on frame and end caps for reference during reassembly[[]
permanent magnetsMagnets should attract steel or iron objects held inside the frameWeak magnets will cause excessive RPM
on No Load Current Draw, Electric Starter test5Do not clean drive assembly while the starter and drive are installedThe cleaning
agent could drain into the starter, washing dirt from the drive into the bearings and commutatorAfter disassembling, clean
each part with grease solvent and inspect6If the pinion does not properly engage the flywheel, the pinion and screw shaft
assembly may be worn, distorted, or dirtyLocate the cause and correct before completing assembly Assembly 1Lubricate the
armature shaft bearing surface with one drop of SAE No.1 oilLubricate pinion helix on armature shaft with OMC Starter Bendix