1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 45Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 45

Shift Cable f21 1Extend shift cable and lubricate with OMC Triple-Guard grease2Verify that the fast idle lever is down in
cable to allow the adjustment in Step 7, or if the gearcase detent does not correspond with remote control NEUTRAL in Step
10, refer to Section for shift rod height adjustment 11Attach shift cable to shift lever pin using locknut and washer supplied
with engineTighten locknut securelyWhen installing OMC Accessory Controls, except for surface mount, the shift cable must
be adjusted and installed when the control and engine are in NEUTRAL12Slip rubber grommet onto control cables and press grommet
into groove in lower engine cover '" 13Inspect installation to ensure that the control cables are attached to the proper
engine levers by lifting the fast idle lever to the START positionIf correctly attached, the throttle cable and engine throttle
lever will moveWhen installing remote control that is not manufactured by Outboard Marine Corporation, you must verify that