1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 142Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 142

25The wrist pin fit is loose on both sidesPush the wrist pin through to free the piston from the connecting rodIf necessary,
all port edges using ball hone or other suitable tool avoid personal injury, wear eye protection and rubber gloves when using
OMC Gel-Seal and Gasket Remover 4Use OMC Gel-Seal and Gasket Remover to remove all traces of gasket, adhesives, and OMC Gel-Sealllfrom
the cylinder block and crankcase5Carefully remove any carbon accumulation from the tops and ring grooves of the pistonA ring
groove cleaning tool can be made by breaking an old ring and grinding an angle on its endDo not damage ring grooves while
cleaning6Thoroughly wash entire cylinder block and crankcase with warmsoapy water to remove all traces of contaminants 7Air
dry cylinder block and crankcaseBlowout all holes and passageways with compressed airClean the center main bearing recirculation
passage with OMC Cleaning SolventClean passage only in direction of fluid flowTo avoid personal injury, wear eye protection