1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 143Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 143

Inspection 1Before any inspection process can begin, all internal components must be clean and free of excess oil 2Make visual
thickInstall seal rings in their original positions on crankshaft after inspection 1421 6Use aeach cylindergauge for inside-reading
micrometer or telescoping or to inspect bore an out-of-round, oversize, tapered conditionBe sure the gauge or micrometer
is perfectly square in the bore when measuring 1431 7Measure eachmeasuredin at least two areas as betweenEach cyl inder shownarea
should be twiceThe difference the two measurements in each area is the cylinder out-of-round dimension The cylinder must
not be out of round by more than 0.004 in(0,10 mm) 1431 S!he dimensional cylinder taper difference between the two areas
is The cylinder taper must not exceed 0.002 in(0,05 mm) r::;l 9The difference between your measurements and standard bore
dimension is cylinder oversizeRefer to Engine Specifications, Section 1, for dimensions The cylinder must not be oversize