1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 145Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 145

LJ installed flush with the cylinder block r:;-J 1115 modelsIf filler blocks were removed, they must be New filler blocks
5To install new lower main bearing: Oil the end of the crankshaftUse OMC Crankshaft BearinglSleeve Installer, PIN 338648,
and place bearing onto crankshaft with lettered side facing the toolInstall bearing until it seats in the crankshaft1s1 6To
install new crankshaft sleeve: Oil the end of the crankshaftPlace the sleeve in OMC Crankshaft Bearingl Sleeve, PIN 338648,
and drive the sleeve onto the crankshaft until the installer contacts the lower main bearing If the installer sticks on the
sleeve after installation, thread OMC Slide Hammer, PIN 391008, into installer and pull offInspect sleeve surface after installingSleeve
must not be used if surface is damagedf61 7Lubricate new driveshaft O-ring and lightly lubricate crankshaft splines with