1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 153Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 153

Installation 1Remove the nuts from the powerhead adapter studs111 2Install new O-ring on the driveshaftCoat the driveshaft
eyeUsing an adequate hoist, lift the powerheadf31 4Install new powerhead to adapter gasket dryUse no sealer5Place the powerhead
onto the adapterRotate the powerhead slightly back and forth to align the crankshaft and the driveshaft splines "'" 3Use
OMCUniversal Puller and Lifting Eye, PIN 321537, Coat the threads of the exhaust housing to powerhead screws with OMC Gel-Seal
II and install themTorque the screws in stages to the following values: Exhaust Housing to Powerhead Screws 16-18 ftIbs(22-24
Nm) PCE0063 f51 f61 7Coat the threads of the adapter to powerhead screws and nuts with OMC Gel-Seal II, and install them