1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 169Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 169

Disassembly To separate the adapter and the inner exhaust housing assembly from the outer exhaust housing, remove the front
Place the upper thrust mount into the adapterPosition radius side of the mount facing aft and "TOP" mark facing 2Place the
mount plate onto the thrust mountf13l 3Apply OMC Nut Lock to threads of the small thrust mount screwHand tighten the screw
in rear holef101 4Check the condition of the seal on the inner exhaust housing and replace if necessaryApply OMC Adhesive
Mto seal surface of the housing before installing new seal5Apply OMC Adhesive to the outside diameter of new grommet and
position the water tube and water tube grommet in the base of the inner exhaust housing6Place new inner exhaust housing gasket