1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 194Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 194

3Place the a-ring Q) in groove in the impeller housing4Lightly coat the exterior of the impeller cup with OMC Gasket Sealing
rJl 2Apply OMC Triple-Guard grease to new impeller a-ring Slide the a-ring down the driveshaft until it contacts the impeller
plater;Ql 3Apply OMC Needle Bearing Assembly Grease to flat area of the driveshaftInstall the drive camThe sharp edge of
the cam is the leading edge during driveshaft rotation 4Slide the water pump assembly down the driveshaftAlign impeller slot
with the impeller camRotate the driveshaft to engage the impeller cam with the impeller, and slide water pump assembly down
over impellerBe sure impeller cam does not fall out of positionVerify that the impeller engages the impeller cam properlySerious
powerhead damage will result if impeller cam is displaced5Align the impeller housing with the gearcaseApply OMC Gasket Sealing