1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 200Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 200

V4If equipped, remove the two retaining rings using OMCRetaining Ring Pliers, PIN 331045Retaining rings are under extreme
Driveshaft Holding Socket, PIN 311875and OMC Pinion Holder, PIN 334455 Pad the handle of the holder to prevent damage to
the gearcase11Pull up on the driveshaft to remove it from the gearcaseThe driveshaft to pinion taper is locking taperIf necessary,
use OMC Puller, PI 390706 CD, and OMC Backing Plate, PI 325867 il, to break the lockInstall the tools as shown by clamping
them around the driveshaft with the tool's set screw aligned with the water pump drive cam slotThen, tighten the set screw
into the slotAlternately tighten the two vertical screws against the backing plate inserted between the puller and the gearcase
until the driveshaft pops loose from the pinion, then remove the tools 12The bearing housingshimsthrust bearing thrust washer