1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 203Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 203

25V4Remove the water intake screen by depressing the tabs and pushing upwardInspect the screen for blockagePropeller Shaft
were not replaced, rotate the needles with your fingers to check for freedom of movementInspect O-ring groove, and sand off
any sharp edges that would cut the O-ring and prevent its sealingV4Thoroughly clean the threads of the four bearing housing
retaining screwsDiscard the retaining screws' seals4Inspect the bearing housing anodeReplace anode if it has eroded to two-thirds
its original size5Oil, then install new bearings in the bearing housing V4use OMC Bearing Installer, PIN 326562, to install
the forward bearing and rear bearing V6use OMC Bearing Installer, PIN 339750, to install the forward bearing and rear bearing