1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 204Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 204

DR2061 DR2062 [] 6V4Install two new seals back to back in rear of the bearing housing using OMC Seal Installer, PI 326551Apply
driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft
bearing surface if the bearing is damaged[] 1Remove the driveshaft bearing housing seal using OMC Puller Bridge, PI 432127,
and OMC Large Puller Jaws, PIN 432129Discard the seal2Remove the a-ring from the bearing housing and discard it3Clean the
bearing housing in solvent to remove sealer from the seal bore and the a-ring groove 4Install new seal in the bearing housing
using OMC Seal Installer, PIN 341439Apply oil to casing of the seal before installingPlace back of seal against tool and
install it until tool is seated Apply OMC Triple-Guard grease to the seal lips after installing5Lightly apply OMC Triple-Guard