1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 206Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 206

2Select the correct gauge and collar: V4OMC Gauge, PIN 328366, and OMC Collar, PIN 341440 V6OMCGauge, PI 328367, and OMCCollar,
pinion to the driveshaft by holding the gauge bar against the bearing housing (between the screw holes) while rotating just
the driveshaft and pinion assembly and measuring the clearance between the gauge bar and the pinionReplace the pinion or
the driveshaft, as necessary, and repeat the check if variance exceeds 0.002 in(0,050 mm) 9Subtract the average clearance
measurement you obtained in Step from 0.020 in(0,508 mm) to determine the correct shim thickness requiredSelect the fewest
number of shims to achieve the correct thickness10Remove the driveshaft from the tool baseRemove the collar and bearing housing
from the driveshaft, and add the required amount of shims Use extreme care when removing bearing housing to avoid damaging
the sealsUse OMC Driveshaft Seal Protector, PIN 318674 11Check shimming by reassembling the driveshaft with shims and placing