1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 210Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 210

21Position the driveshaft thrust bearingthrust washerand shim(s) (selected earlier) on the driveshaftin the order shown I1ID
taper and install the driveshaft25Lightly coat the threads of the pinion nut with outboard lubricant and install on the driveshaftTurn
the driveshaft by hand to engage the nut26Turn the gearcase right side upUsing OMC Driveshaft Socket, PIN 311875, and OMC
Pinion Nut Holder, PI 334455, torque the pinion nut to 70-80 ftIbs(90-108 Nm)INotel Overtorquing or undertorquing the pinion
nut will reduce pinion lifeDo not reuse damaged pinion nuts 27Position the washers on the driveshaft bearing housing screwsApply
OMC Gasket Sealing Compound to the threads of the screwsInstall and tighten screws to torque of 168-192 inIbs(19-22 Nm)28Oil,
then install the thrust bearing Q) and large thrust washer CD on the hub of the reverse gearSlide the reverse gear onto the