1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 211Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 211

29Models using retainer plate and retaining rings: Slide the bearing housing retainer plate into position over the propeller
at the bottomPress the bearing housing into the gearcase and tap the housing in with soft face mallet to seat the -ring Apply
OMC Gasket Sealing Compound to the threads of the four retaining screwsInstall two of the screws into the bearing housing
finger tightRemove the guide pins and install the other two screwsThen, tighten all four screws to torque of 120-144 inIbs(14-16
Nm)30Models using bearing housing retainers: Carefully apply OMC Gasket Sealing Compound to the a-ring flange and aft support
flange of the bearing housingDo not allow sealer to contact either forward thrust surface or bearings in the housingInstall
the housing in the gearcase with screw holes in vertical position and anode facing downPress the bearing housing into the
gearcase and tap the housing with soft face mallet to seat the a-ring Install the two retainers, washers, and screwsApply