1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 220Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 220

19Remove retainer ring if requiredDiscard retainer ring 20To assemble bearings to driveshaft, install new retaining ring
it contacts the lower bearing22Using retaining ring pliers, install retaining ring with sharp edge facing outMake sure the
retaining ring is seated in its groove in the driveshaftWear safety glasses and proceed with care to avoid unsnapping the
ring from the pliers [!ID 23Install thrust washer against upper bearing with dished center section facing upwardPlace upper
seal carrier assembly onto the driveshaftApply OMC Triple-Guard grease to two new O-rings and install on upper seal carrier[1ID
24Fill bearing housing cavity with OMC Marine Wheel Bearing Grease 20 25Heat the bearing housing slightly with propane torch