1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 279Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 279

7(continued) If no voltage at V3disconnect bluewhite tilt limit switch bullet connectors and re-connect to by-pass tilt limit
relay sockets and engine ground If voltage at V5, go to Step 1414Connect voltmeter black lead to clean engine ground, and
voltmeter red lead to V7 (green white) 15Push control box DOWN trim button If no voltage at V7, check control box trim switch
and wiring, and go to Step 16 If voltage at V7, go to Step 1616Push lower motor cover DOWN trim button If no voltage at V7,
check for voltage at greenwhite bullet connector out of lower motor cover trim switchCheck for voltage at red connector that
supplies lower motor cover switch If voltage at V7, go to Step 17 17Reinstall DOWN relayPush blades only halfway into DOWN
(green) socket18Push DOWN trim button and check for voltage at If no voltage at va, go to Relay Ohmmeter Test If voltage
at va, go to Step 19 relay blade (M terminal of relay) 19Disconnect trim motor's blue and green power wire connector (leave
relay in socket)20Push DOWN trim buttonCheck for voltage on green wire If no voltage, check green wire from relay socket