1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 285Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 285

t=J the UP circuit f51 7Install pressure gauge and adapter "A" to check problems in Tighten gauge and adapter lightly to
and 8, install pressure gauge and adapter liB" to check problems in the DOWN circuit12Starting with the tilt cylinder fully
extended, run the unit DOWN The gauge should show 0-200 PSI (0-1379 kPa) as the tilt cylinder is retracting The gauge should
show (5516 kPa) as the unit stallsapproximately 800 PSI Release the switch and watch for pressure dropThe stall pressure
reading must not drop by more than 200 PSI (1379 kPa) after the motor stops13If your test results vary from those in Step
12, problem in the DOWN circuit is indicatedRefer to Hydraulics Troubleshooting, this section i then UP again to vent any
high pressure before removing the gauge "'" 14After tests are complete, jog the unit UP, then DOWN, i Ibs(5-6 Nm)Insta" retaining
ring with sharp edge of ring "'" 15Install the manual release valve and torque to 45-55 in facing outManual release valve