1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 311Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 311

t=l the UP circuit 8Install pressure gauge and adapter "A" to check problems in Tighten gauge and adapter lightly to 5-10
faults t=l adapter "8" to check problems in the DOWN circuit 12Following Steps through 9, install pressure gauge and 13With
all cylinders completely extended, begin running the unit DOWN The gauge should show approximately 800 PSI (5516 kPa) as
the cylinders are retracting The gauge should show approximately 900 PSI (6206 kPa) as the unit stalls The stall pressure
reading must not drop by more than 200 PSI (1379 kPa) after the motor stops14If your test results vary from those in Step
13, problem in the DOWN circuit is indicatedRefer to Page 8-45 for list of possible faults 15After tests are complete, install
the manual release valve and torque to 45-55 inIbs(5-6 Nm)Install retaining ring i the hydraulic unit's shock absorption