1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 317Get this manual

1995 Johnson Evinrude "EO" 90 CV 85 thru 115 Service Manual, P/N 503150, Page 317

23 C0A2433 1201 cUsing sharp screwdriver, pry the scraper out of the end cap Discard the scraperdPry the O-ring out of the
threads on the tilt rodUsing OMC Tilt Cylinder Seal Protector, PIN 326005, slide the end cap onto the rod COA2435 1261 iClean
any Locktite material from the threads on the inside of the nutSpray threads with OMC Locquic Primer and let dryApply small
amount of OMC Nut Lock to the threads of the nutSlide the washer over the threadsInstall the nutTighten the nutto torque
of 58-87 ft.lbs(79-118 Nm).lffor some reason the rod has been unscrewed from the eyelet, clean the threads of the rod at
that end and the threads inside the eyelet with OMC Locquic PrimerApply small amount of OMC Nut Lock to the threads, thread
the rod into the eyelet, and torque both the nut and the rod into the eyelet at the same time15Service the Presto lite piston